Backup Assist downloading install#

Install BackupAssist v9 or later onto the computer (if it’s not already running v9 or later).Select a BackupAssist computer to be the Site Controller for the site you want to set up.If there is only one BackupAssist computer in a site, that one computer will be the Site Controller. These steps are performed on one computer in each site - the Site Controller. Step 2: Set up a Site Controller for each site This setup includes creating the username and password. Install MultiSite Manager onto this computer and run the initial setup when you first launch the MultiSite Manager web application.MultiSite Manager can be installed onto a Site Controller, but the Site Controller will still need to be registered to the MultiSite Manager so that the computer can perform both roles. This computer will need internet access, a globally reachable hostname or IP address and an SSL certificate assigned. Select a computer to be your MultiSite Manager.Step 1: Set up a MultiSite Manager computer These steps summarize the information found in the following sections of this guide. This walk through explains the sequence of steps that should be followed to implement a MultiSite Manager solution. BackupAssist 9.2 and later computers are automatically detected by the Site Controller and added to the MultiSite Manager for remote management.It is registered to the MultiSite Manager using the BackupAssist Remote tab’s Remote Setup window. The Site Controller is a BackupAssist computer.MultiSite Manager is installed and configured on a computer.The Site Controller computer can also run MultiSite Manager if required. This graphic shows how a single-site solution is implemented-in the same way as a multi-site solution, but with just one site to manage. The Site Controllers are all connected to the MultiSite Manager. Multiple Sites: each BackupAssist computer is connected to the Site Controller for their site.Single-site: each BackupAssist computer is connected to a single Site Controller, and that Site Controller is connected to the MultiSite Manager.MultiSite Manager can be used for both single-site and multi-site implementations.

Backup Assist downloading windows#

Support for Windows Server 2003 is explained on our Windows 2003 page.

Microsoft Internet Explorer 9 and above.

The following web browsers are supported by the MultiSite Manager’s web application:

Backup Assist downloading full#

If you use the Remote Session feature to access a Windows 7 or 8 workstation, you will be presented with a full Microsoft Remote Desktop session, which is used to open BackupAssist.

BackupAssist will automatically enable Remote Desktop for you, when you select Enable Remote Management, in the Remote Setup screen.

Microsoft Remote Desktop must be enabled on a computer before MultiSite Manager can connect to it and initiate a remote session.

This feature uses Microsoft Remote Desktop. MultiSite Manager can open a remote BackupAssist installation, and run it as a local session on the computer running the MultiSite Manager web application.

MultiSite Manager can administer BackupAssist Classic v9 and later installations.All remotely managed BackupAssist computers and Site Controllers must have internet access.

MultiSite Manager communication over the internet should be secured using MultiSite Manager HTTPS and Certificates.The MultiSite Manager’s computer requires a globally reachable hostname or IP address.Windows Server 2016 - Supported from v9.5.MultiSite Manager can be installed onto the following operating systems.